i have a vu+ solo and image version was 5 .
i download new image 9.0.3 and when i installed it in my solo i had green light only without picture.
i installed image version 6-7 and original but same and green light again.
i installed cfe_solo_2.0 and after that i have red light and i cant install any image in my solo.
when i connect usb stick to my solo no change and every time red light.
my solo is original and not clone.
i see this post in internet but i cant do this i test with rs-232 cable and null 9-9 but no success.
Alles anzeigen
i download new image 9.0.3 and when i installed it in my solo i had green light only without picture.
i installed image version 6-7 and original but same and green light again.
i installed cfe_solo_2.0 and after that i have red light and i cant install any image in my solo.
when i connect usb stick to my solo no change and every time red light.
my solo is original and not clone.
i see this post in internet but i cant do this i test with rs-232 cable and null 9-9 but no success.
Quellcode
- Switch the box off, on the rear side.
- choose in putty for serial connect, speed must be set to 115200 and choose you`re comport.
- Put the box on, when you`re connection is oke, you wil see some text scrolling over the putty screen.
- Now use the ctrl + c key to stop the booting.
- copy the following line in the screen:
- boot -z -elf flash0.kernel: 'rootfstype=jffs2 root=/dev/mtdblock0 rw mem=0x8000000 bcmrac=3`
- The box now reboot from the flash, so watch you`re box.
- Then open telnet with dcc and put in the following line.
- flash_eraseall /dev/mtd5
- and after that the following line
- reboot -f
- Then you`re box is running again.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von hu016865 ()