Cześć,
ściągnąłem nową wersję (7.2) OpenPli z oficjalnej www, do mojego vu+ zero. Po próbie wgrania zgodnie ze schematem załączonym poniżej, mam tylko teraz ekran początkowy jak wcześniej, a po chwili telewizor pokazuje informację o braku sygnału na złączu HDMI. Sprawdzałem na różnych pendrive'ach, różne wersje oprogramowania. Może ktoś wie o co chodzi?
Flashing the Receiver.
1) Power off the receiver
2) Insert the USB stick containing the image file possible.
4) Power the receiver on.
5) The WHITE L.E.D will quickly flash two or three times then start to fade in and out slowly.
6) Once completed the WHITE L.E.D will flash rapidly.
7) If in doubt leave the receiver for a full 10 minutes before powering down and removing the USB stick.
Power on the receiver, it should now boot into the new image.
ściągnąłem nową wersję (7.2) OpenPli z oficjalnej www, do mojego vu+ zero. Po próbie wgrania zgodnie ze schematem załączonym poniżej, mam tylko teraz ekran początkowy jak wcześniej, a po chwili telewizor pokazuje informację o braku sygnału na złączu HDMI. Sprawdzałem na różnych pendrive'ach, różne wersje oprogramowania. Może ktoś wie o co chodzi?
Flashing the Receiver.
1) Power off the receiver
2) Insert the USB stick containing the image file possible.
4) Power the receiver on.
5) The WHITE L.E.D will quickly flash two or three times then start to fade in and out slowly.
6) Once completed the WHITE L.E.D will flash rapidly.
7) If in doubt leave the receiver for a full 10 minutes before powering down and removing the USB stick.
Power on the receiver, it should now boot into the new image.